Bind container ports to the host预计阅读时间: 3 分钟
The information in this section explains binding container ports within the Docker default bridge. This is a
bridge network named
bridge created automatically when you install Docker.
Note: The Docker networks feature allows you to create user-defined networks in addition to the default bridge network.
By default Docker containers can make connections to the outside world, but the
outside world cannot connect to containers. Each outgoing connection will
appear to originate from one of the host machine’s own IP addresses thanks to an
iptables masquerading rule on the host machine that the Docker server creates
when it starts:
$ sudo iptables -t nat -L -n ... Chain POSTROUTING (policy ACCEPT) target prot opt source destination MASQUERADE all -- 172.17.0.0/16 0.0.0.0/0 ...
The Docker server creates a masquerade rule that let containers connect to IP addresses in the outside world.
If you want containers to accept incoming connections, you will need to provide
special options when invoking
docker run. There are two approaches.
First, you can supply
docker run which
is a blanket operation that identifies every port with an
EXPOSE line in the
--expose <port> commandline flag and maps it to a host
port somewhere within an ephemeral port range. The
docker port command then
needs to be used to inspect created mapping. The ephemeral port range is
/proc/sys/net/ipv4/ip_local_port_range kernel parameter,
typically ranging from 32768 to 61000.
Mapping can be specified explicitly using
-p SPEC or
It allows you to particularize which port on docker server - which can be any
port at all, not just one within the ephemeral port range – you want mapped
to which port in the container.
Either way, you should be able to peek at what Docker has accomplished in your network stack by examining your NAT tables.
# What your NAT rules might look like when Docker # is finished setting up a -P forward: $ iptables -t nat -L -n ... Chain DOCKER (2 references) target prot opt source destination DNAT tcp -- 0.0.0.0/0 0.0.0.0/0 tcp dpt:49153 to:172.17.0.2:80 # What your NAT rules might look like when Docker # is finished setting up a -p 80:80 forward: Chain DOCKER (2 references) target prot opt source destination DNAT tcp -- 0.0.0.0/0 0.0.0.0/0 tcp dpt:80 to:172.17.0.2:80
You can see that Docker has exposed these container ports on
wildcard IP address that will match any possible incoming port on the host
machine. If you want to be more restrictive and only allow container services to
be contacted through a specific external interface on the host machine, you have
two choices. When you invoke
docker run you can use either
-p IP::port to specify the external interface
for one particular binding.
Or if you always want Docker port forwards to bind to one specific IP address,
you can edit your system-wide Docker server settings and add the option
--ip=IP_ADDRESS. Remember to restart your Docker server after editing this
Note: With hairpin NAT enabled (
--userland-proxy=false), containers port exposure is achieved purely through iptables rules, and no attempt to bind the exposed port is ever made. This means that nothing prevents shadowing a previously listening service outside of Docker through exposing the same port for a container. In such conflicting situation, Docker created iptables rules will take precedence and route to the container.
--userland-proxy parameter, true by default, provides a userland
implementation for inter-container and outside-to-container communication. When
disabled, Docker uses both an additional
MASQUERADE iptable rule and the
net.ipv4.route_localnet kernel parameter which allow the host machine to
connect to a local container exposed port through the commonly used loopback
address: this alternative is preferred for performance reasons.